The Band indicators (Laser, Ka, K, X and Decimal Point for Ku) will flash if the corresponding Band is On and remain dark if the corresponding band is Off.
On V1s with software version 3.891 and higher, P will indicate Band Programming changes only. On V1s with serial numbers ending in 0600 or higher, a flashing red LED just to the right of the Bogey Counter during the sequence above indicates that Ku coverage has been activated. If the unit has been changed, P will appear briefly in the Bogey Counter soon after V1 is switched on (after the lamps-on test, but before the Mode indicator appears.). How to tell if V1 Gen1 has been changed from factory settings. The changes you programmed will be retained in memory. 
NOTE: If you need to return to an earlier Character in the sequence above, we recommend you switch off the power momentarily, then restart at step I above. The Feature State is changed by pressing and holding the Control Knob until the arrow switches to the opposite direction (takes about 3 seconds). The Feature State is indicated by direction arrows on the Radar Locator. To select the next Feature Character in the sequence, press and immediately release the Control Knob. The feature character is indicated in the “Bogey Counter”. Press and hold the Control Knob until the Front Arrow is illuminated to return all programming features to the factory default. Note for V1 Gen1s with software version 3.891 and higher allow the user to reset all feature programming to factory defaults during the display of the software version. How to reinstate Factory Default settings. Press and immediately release the Control Knob to exit software-version display. 
Note your software number, then see the table below for features that are programmable in your unit. The software-version number is four digits that display one digit at a time in the Bogey Counter – example: 2.869. Press and immediately release the Control Knob to display software version. 
Starting with the Control Knob in the “off” position, Press and hold-in Knob and at the same time turn the Knob “on ” continue holding in the Knob until all front-panel lights are on (takes about 5 seconds). Features that are Essential To Full Protection are marked with the so change these at your own risk. WARNING: Important radar alerts may be blocked by changes in factory settings.
0 kommentar(er)
